1 / 3
Speedybee Mario 5 BN-220 GPS top mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For mounting a BN-220 GPS where the GoPro mount would usually be placed on the Speedybee Mario 5
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This part allows mounting a BN-220 GPS where the GoPro mount would usually be placed on the Speedybee Mario 5.
I don't have a GoPro or other camera attached so it just made sense to me to have the GPS in that spot.
If you use a very large battery the GPS may get blocked. Letting the drone aquire satellits without the battery on top and then attaching it before taking of helped me but I didn't test how precise the GPS is afterwards. So I wouldn't recomment doing so.
Mounting instructions:
- attach the cable to your flight controller and route it out the front of the mario 5 (hang it out over the camera)
- insert the two threaded tubes into the printed adapter
- slide the GPS module into the adapter
- put the adapter into your mario 5 above the cable and screw in the screws
- insert the cable into the adapter. Use a tool to oush it in firmly while holding the GPS module to prevent breaking the 3D printed part