Guide for PTFE tube with filament rod for Creality dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The model holds a PTFE tube with filament for smoother direction.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 183
- Wydruki
- 0
- Wyświetlenia
- 705
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
PTFE tube holder for Creality Dryer.
The model is securely attached to the Creality dryer with a bolt-screw connection. The PTFE tube is conveniently inserted into the hole and does not bend, the PTFE tube is not pulled into the dryer. The PTFE tube is easy to insert and easy to remove. The filament enters the PTFE tube at the correct angle.
Just a nice upgrade.
*************************************************************************************************Parts:
The black parts are the rubber inserts of the dryer.
The yellow parts are the pressure plates.
The orange parts are the bolt and nut for fixing.

*************************************************************************************************Assembly:
1. Place the larger yellow pressure plate on top as shown in the picture.

2. Insert the orange threaded rod into the pressure plate and push it all the way in. It should go through the rubber seal and come out inside the dryer chamber.

3. Put the lower pressure plate (smaller yellow part) on the threaded part with the wide part up. The pressure plate is put on the threaded part from the inside of the dryer chamber.

4. Hold the lower pressure plate, put on the nuts and tighten it.

5. Congratulations, you have completed the assembly.
*************************************************************************************************
Thank you for your attention! I hope this model was useful to you.