Handlebars for Segway NINEBOT MAX G3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made these handlebars so I can push my kids on the scooter. DO NOT USE FOR RIDING.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 786
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
I made these handle bars so I can push my kids on the scooter, I have been using these for couple months and they work great, without any failure. You can easily remove the handlebars with allen key when not in use. I DO NOT recommend to use these in higher speeds or to hold on when driving. Use at you own risk.
You can also check out my other model: Carry handle for Segway NINEBOT MAX G3
Additional hardware:
2x M5x16 socket head screw
2x M5x90 socket head screw
2x M5 DIN 433 washer
2x M5 DIN 985 nut
2x M5 DIN 562 nut
Recommended - Blue Loctite Threadlocker
Print settings:
Printed from PETG or ASA
25% infill
8 perimeters
Use pause print at layer for insertion of the nuts (2x M5 DIN 562) in the part “Scooter clamp 2”
Use Fuzzy skin function on outer walls of “Scooter handle” for added grip.
Print:
1x Scooter handle
1x Scooter grip 1
1x Scooter grip 2
Assembly:
I recommend to use blue Locktite on all bolts to prevent loosening
Put M5x90 bolts through the handle and secure it from falling out when disassembled with M5 DIN 433 washer slightly pushed in with soldering iron.
Push the M5 DIN 985 nuts into the clamps
Attach handles to each clamp, then you can put it on to the scooter stem and screw in two M5x16 bolts through the clamps until they catch the nut in the other piece, then align your handles and tighten the bolts. Do not over tighten so you dont split the clamps, it helps to tighten both sides at the same rate.
