kleenex box car clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This box clips to a pocket on the back of a car seat to keep a kleenex box within reach and off the floor.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 110
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Need a place to put a kleenex box in the car so it's within reach and not rolling around on the floor? This box will clip to the pocket on the back of a car seat.
I used a higher angle from the clip to the upper edge of the box and increased the base of the clip to avoid supports. The clip and box walls are 2mm thick with 100% infill for strength with a small chamfer on inside and outside corners.
The lower box corners lifted a little off the bed during the print (elephant foot), especially the corners closer to the clip – see pictures. I suspect this was due to print settings, but it could be design related. I had the bed temp set to 65C for first and all layers to improve bed adhesion. I also had a 1mm x 1mm chamfer on the lower inside corners of the box to prevent lifting. Please let me know if you have the same problem with this print.
This print took over 11 hours and 67m filament, but this could be reduced by making the box shorter or adding decorative holes on the sides. I made it taller so the box would be a 118mm cube.
Feel free to modify the attached stl file or copy the design from my onshape workspace, but please share your updates and link back to this page. I'd like to see what people do with this design! Thanks!