1 / 7
Minisforum MS-A1 Noctua NH-L9a AM5 Mount — zdjęcie 1
1 / 7

Minisforum MS-A1 Noctua NH-L9a AM5 Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mounting posts to allow the mounting of a Noctua NH-L9a to a Minisforum MS-A1 motherboard

Ocena
0 / 5
Polubienia
14
Pobrania
80
Wydruki
0
Wyświetlenia
1892
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

The Minisforum MS-A1 is an awesome low power motherboard case combo, but the cooler is weak and kind of noisy. The cooler mount is almost but not quite AM-5 cooler compatible. This design adapts the NH-L9a to the slightly smaller mounting pattern on the MS-A1 motherboard. The NH-L9a is more capable than the stock cooler and almost silent at most speeds 50% or lower.

This design pairs well with my MS-A1 Noctua Case - check it out in my profile.

Note that you'll need a solution to power and control the fan. The easiest way is to wire a 4pin Molex Picoblade to standard 4 Pin fan header. Instead I designed my own thermal fan controller instead, as the built in motherboard fan curve is non-customizable. (Github link to fan controller)

Requires:

  • NH-L9a AM5 mount kit (if you don't have it, you can get it for free here)

  • 2x Button head M2.5x8mm Screws (To mount adapter posts)

  • 4x Button head M2.5x12mm Screws (To mount cooler)

  • 4x M2.5 washers

  • 2x M2.5x3x3.5 heat set insert

Directions:

  1. Print only TWO of these mounting posts.

    • Recommend ABS or ASA for heat resistance

    • Any print settings will work but I used 0.2mm layers with 3 walls. That should make it 100% filled for maximum rigidity.

  2. Add two M2.5x3x3.5 heat set inserts

  3. Screw the shorter end of the posts to the two rear-most cooler mounts using M2.5x8mm button head screws

  4. Put thermal paste on the CPU

  5. Put the cooler upside-down on a flat surface with the mount adapter posts farthest away from you.

  6. Lower the motherboard down so that the rear mounting holes line up with the mount adapter posts

  7. Insert 2x M2.5x12 screws and washers into the rear-most motherboard cooler mount and tighten down the posts. Ensure you provide even torque to both.

  8. Now insert the front-most M2.5x12 screws and washers and tighten down gently until you start to feel a little resistance and the cooler is level and making good contact with the CPU. Check the height from the side of the case to ensure the cooler is level and the distance it sits above the motherboard tray is the same at the front and back. Don't overtighten, or the cooler will tilt and lift off the CPU. Note that I am using cap head screws but button head is recommended otherwise one of the front screws will interfere with the M2 mounting slot next to the underside cooler.

  9. Flip it over, figure out how to wire up your fan and enjoy the silence!

Tagi