Thule Urban Pro Glide 3 AirTag holder (customizable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created an customizeable AirTag holder for my Thule Urban Pro Glide 3 chariot/buggy.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 404
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
I created this AirTag holder for the Thule Urban Pro Glide 3 Charriot. It is placed at the underside of the front-wheel holder to hide the AirTag's existence. It fits quite tight and should hold it's position without the need of any glue. Though I would put some double-sided tape at both sides - just to be sure.
I printed the prototypes in regular PLA until it fitted. The final one (shown in the pictures) is created with Extrudr ASA for more durability.
Instructions:
You can print it with any layer-height. I used a 0.6mm nozzle, 0.2mm layer height and an infill of 25%. But I guess any settings are fine.
After printing all 4 parts, place the AirTag in the center and move both sides until they fit the center seamlessly. I created an offset of 0.09mm. On my prototypes this was good enough for a tight fit, that can also be removed without destroying the parts. After puzzling together, push it gently into the down side of the front-wheel holder. The two gaps on both left & right part, are designed to fit exactly into the two cross braces.
Feel free to adjust the model if you have any trouble. It's designed parametric, changing any values should just adopt to the model without any issues.