NerdQaxe+ Extra Simple Cooling Bracket for OC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cooling bracket for NerdQaxe+ for overclocking with 2x 120mm fans
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 916
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
This model is an extra simple bracket to assemble the NerdQaxe+ with 2x 120mm fans and its original power supply altogether. And yes! It looks like a key. :)
The fans are intentionally displaced (rear fan is higher) to achieve better cooling. Both fans achieve best performance if blowing towards the PCB. Tests with enclosure and/or ducts revealed that this simple approach is quite good. The power supply is cooled with waste air.
Temperature with OC at expected 2.8Th/s:
- Frequency: 550MHz
- Core Voltage: 1350mV
- Power consumption: 69W
- Fan Mode: Classic AFC
- ASIC Temp: 53°C
- VR Temp: 51°C
Requires:
- Screws:
- 10x M3x10
- model explicitly requires M3 rather than self-tapping M4 (limited space)
- Fans: 2x 120mm (if different models, prefer stronger one as front fan)
- Brackets: 2x (print time <1h; for left side print mirrored)
Print settings:
- wall generator: classic
- scarf seam: contour and hole, aligned
- layer height: 0.22mm
- walls: 4
- top shells: 6
- bottom shells: 4
- infill: 0%
- skirt yes, brim no
See also FreeCad project file on GitHub: nerdaxe-plus.FCStd