1 / 3
FormD T1 V2.1 / NCASE T1 2.5 GPU Anti-Sag Bracket 5080/5090 FE
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anti sag bracket to secure the RTX 5080 / 5090 Founder Edition air cooler and eliminate sag.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 145
- Wydruki
- 0
- Wyświetlenia
- 2261
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (0)Kolekcje (11)Powiązane
What is this?
GPU Anti sag bracket to secure RTX 5080/5090 Founder Edition cooler from the rear side to eliminate sag.
What have I modified from EIGA's original model?
- Adjusted the model to fit RTX 5080/5090 FE.
- Made the structure more solid (fatter).
What do I need?
The 3D printing version requires one M3 threaded brass insert.
- Model is created for insert size: M3xL3xDD4.2
One longer M3 screw.
- I used M3x12.
Three shorter screws.
- I used M3x6. The ones that come with the NCASE T1 2.5 are compatible.
Does it support my setup?
Configurations supported:
- 3 slot (not tested!)
- 3.25 slot → I am personally using this (verified)
I am finding it very difficult to assemble the bracket after the GPU.. :(
- It's a bit tricky to install.
- First, I screwed the GPU mount to the GPU (after removing the two really small Torx screws first).
- Then I set up the GPU bracket in the case, keeping it as close to the edge as possible, and pushed the GPU mount part of it toward the front of the case.
- After that, you can just sneak the GPU in.
- Finally, align the two pieces and screw them together with a longer screw (for example, an M3x12).
Note: Be sure to use a high-temperature-resistant filament.
Credit and gratitude to EIGA, the original creator.
Hope you guys enjoy the model!