PET Bottle Foam Gun for Garden hose. Constant Soap dispenser.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CulinaryDiver original design. I adjusted so it prints laying flat and drains bottle when water flow trough. No Glue.
- Ocena
- 4,6 / 5
- Polubienia
- 422
- Pobrania
- 1018
- Wydruki
- 4
- Wyświetlenia
- 8196
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
You will need a type of valve on the hose, like i have in picture.
Model need 1 o-ring on gardena plug and 1 big o-ring inside nozzle or else user WILL be wet.
I use o-rings but designet a TPU seal too.
I have testet TPU seal and it works, but should be glued in so it never falls off.
Mini version. 3.5mm SoapHole. Original is 2mm.
Mini version drains 0.5l bottle in 20sec without nozzle.
Mini version drains 0.5l bottle in 40 sec with ‘slitt Nozzle’.
Mini version drains 0.5l bottle in 50sec with ‘multible holes nozzle’.
Need 9mm tube down in bottle to work. (9mm Inside tube)
Link for the valve for ¾ Thread Model, still have to turn off water when change back to clean water but makes it operate able.
https://www.printables.com/model/1306261-garden-hose-valve
¾ 2x Female and ¾ 2x Male with printable overhang at low layer height.
https://www.printables.com/model/1314661-34-hose-connection-to-gardena-quick-connect
Or Search- 3/4 hose connection to gardena quick connect.
May have to use some sandpaper if gardena coupling doesn't fit, should be tight fit.
Need support only on build plate and only for gardena plug, normal support is better than tree support on this.
I printed with PETG and 0.6 mm nozzle. (3.5hour)
initial layer height - 0,2mm
layer height 0.2
3 Walls.
7 Bottom & 7 Top.
20% Gyroid infill.
Normal Support only for gardena plug.
