Home Decorators Ceiling Fan remote holder

Switchplate-mounted holder for Home Decorators ceiling fan remote control. Designed for toggle-switch-type switchplate. Uses original switchplate hardware and mounting screws. Inside surface of holder is contoured to snugly fit remote. Design provides back support, allowing remote to be used while mounted on the wall without torqueing the holder. Design skeletonized to reduce filament requirements while still providing rigidity.

I switched out my ceiling fans, and with the remote control, I had an extra spot available on the wall switchplate. I originally replaced the toggle switch with a blank, but I really wanted my fan controls mounted on the wall. I'm planning on doing a couple more iterations of this design, 1 for a single gang plate replacement with integrated holder to the side, and 1 for a dual gang plate replacement just like the picture but integrated as a single piece.

Please provide feedback - this is my first upload! Enjoy!

---

I've now added 4 more models. These should be printed standing vertically, right-side-up. I essentially copied Leviton's switchplate, but on the back side, I chamfered all the overhangs to 45 degrees so you don't need supports on the back. You will, however, need supports under the remote holder floor, between the floor and the retaining band, and for the toggle switch cutout. The difference between the 1-gang and the 2-gang versions is the 2 extra holes for mounting screws for 2-gang boxes.

Enjoy!!

Print Settings

Printer Brand:

Creality

Printer:

**Rafts:**

No

Supports:

**Infill:**

30

Filament: JAYO PLA white

Category: Organization