1 / 12
Sidewinder X1 Bimetal heatbreak for Artillery Hornet — zdjęcie 1
1 / 12

Sidewinder X1 Bimetal heatbreak for Artillery Hornet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Spacer/adapter to use SW X1 bimetal V6-style heatbreak on Artillery Hornet

Ocena
0 / 5
Polubienia
3
Pobrania
10
Wydruki
0
Wyświetlenia
178
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I ordered a bimetal heatbreak for my Hornet to use with V6 Cht clone nozzle, which was advertised as a replacement for Sidewinder and Hornet printers.(some vendors sell it as E3D option) When it arrived, it was short by 1.5mm and had a bit different geometry.

It should be a drop-in installment if your printer is dimensionally accurate. This heatbreak has shorter thread for V6 style nozzles unlike the MK8 that the stock Hornet uses, but it should allow installing better V6-compatible heatblocks like Volcano in future.

Last picture is technical drawing of said heatbreak for you to buy right version.

BE AWARE
The V6 nozzle will be deeper in heatblock and therefore shorter outside. You will need to move Z-endstop switch lower and have AW cooling duct because the stock one will be too low. Dual 5015 duct like this:
https://www.printables.com/model/262009-artillery-hornet-dual-5015-print-head-cooling-duct
will also be too high.

I also cut a bit from silicone sock for it to not interfere.

Aside from that - happy printing!

Tagi