Rubber sealed top for Ozark Trail mug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you lost your original rubber sealed top, here's a replacement / spare
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
At a point in time when I had misplaced the lid to my travel coffee mug, I designed this sealing replacement top.
It prints in two pieces. One is the hard plastic lid. The other is the soft rubber seal.
The best TPU for this is Ninjaflex. But if you have moved past the MK3S series, printing Ninjaflex has gotten quite hard to pull off. After reading some blogs and suggested tunings to the Prusa supplied Ninjaflex filament profile - I was able to print this simple rubber seal on my MK4S. The MK3S would do a better job, so if you still have that choice, I recommend it.
Once printed, clear the channel in the main plastic part. Then insert the rubber part - it will easily stretch over the opening and snap into the channel. I recommend the wide part be “down”.
The lid seals the cup quite well, and will even survive tipping over and not spilling the content. There is no opening in the lid (original version). To drink your coffee, remove the lid.