Sabrent 252W charger Skadis adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to hang the Sabrent 252W charger to an Ikea Skadis board
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
After receiving my charger, I had to find a way to make a useful “charging station” corner. Ikea to the rescue, alongside the Skadis Universal Hook system!
Hardware
This design uses minimal hardware in order to securely mount it to a Skadis board:
- 4x M3x5x4 heat set inserts (the same used for Voron machines)
- 4x M3x8 FHCS
- The wall mount plate included with the charger
Printing parameters
3 walls is a minimum, 4 walls is recommended. The charger is heavy, and you don't want the inserts ripping out. Infill doesn't matter much, 15 - 20% Cubic or Cross Hatch is sufficient.
My sample was printed in ASA, but only because it was already loaded. Any material would work, as it's not highly load bearing. Make sure layer adhesion is not an issue with your machine.
Print the piece with the four holes facing the build plate. No supports required, as there is only minimal bridging, and they'd be impossible to remove.
Instructions
First, melt the inserts into the four corners of the part. Then, align the included plate, and screw it into the printed part.
There is provision for 3 hooks, however, I have found that two were completely fine, and much easier for installation. Install the hooks first on the board, and only then the adapter to the hooks. You're done!
This model requires at least two of the Skadis Universal Hooks, by CSD_Salzburg. Find them here