1 / 2
Adjustable furniture feet using an M8 bolt
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Suitable for wooden furnitures/legs using a standard M8 bolt and nut.
- Ocena
- 5 / 5
- Polubienia
- 449
- Pobrania
- 541
- Wydruki
- 4
- Wyświetlenia
- 2418
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 4) (Komentarze: 7)Remiksy (0)Kolekcje (650)Powiązane
Simple adjustable feet based on an M8 bolt and nut. I am using them for a table.
The upper part fits into a 25mm hole drilled into the wood with a 25mm forstner bit.
Printed in PLA. I printed the upper part with the "fuzzy skin" option in the slicer to make the insert hold better in the wood. I was plannig to glue them in place but the press fit was enough to hold them.
If the legs are angled, the feet can be replaced by this ball-joint feet:

