TF2 Scattergun (Nerf blaster mod from Sillybutts SLAB)

If you want to buy me a coffee :) https://buymeacoffee.com/methanejuice

20250607 Update:

MuzzleA (1) wrong file, correct version updated

This will need two sets of SLAB hardware (12 in barrel) and will need the following additional hardware:

• M4 16mm Clevis Pins qty 1

• #10-32 x 1" Pan Head qty 2

• 2 drum springs

Follow the assembly steps for the SLAB, and apply the following differences:

When strapping the elastic band around “MuzzleA” only ONE time, going around the part like the path in the image, put a #4 Flat Head screw at the green arrow location

Put two of the longest Clevis Pins from the kit in these two locations. #1 will not go all the way, but will be enough, place a piece of tape over it to secure. 

The front assembly is secured by two #4 Flat Head screws

Install the bars (qty 2) the other way around

The M4 16mm Clevis Pins go here, it should stay in place without a retaining pin o the other side

Use another piece of the longest Clevis Pins here to secure the “CatchPusher”

Once you assembled the front and back section like in the SLAB guide, plus the changes above, and are ready to join the two sections, use 1" #10-32 Pan Heads to join them

Join the two mag releases with two #4 Flat Heads

Assemble the barrels like so using #4 Flat Heads

Slip on the barrel at an angle like so, alining the front, sticking the aluminum bar and the real barrel in their sockets

Once both sides are done, slip in the drum from the back like so, and put in all the #4 Flat Heads

and finally, install the “Front Gard_Ver2”, and the dual magazine