Quanum Trifecta long rear landing gear
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've designed my own custom longer rear landing leg to fit my printer (maximum size of 8cm) and still be as long as…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I've designed my own custom longer rear landing leg to fit my printer (maximum size of 8cm) and still be as long as possible.
As you can see, I like to add a small piece of heat shrink tubing to avoid scratching any surfaces my copter is standing on.
Watch a time-lapse of the print process
Print Settings
Printer:
Fabrikator Mini
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
50%
Notes:
Contrary to what you see in my YouTube video, I recommend printing the part standing upright, not lying with the flat side down. This will increase the strength of the little stow nub.
Category: R/C Vehicles