Adjustable Weighted Laptop Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fillable adjustable vertical laptop stand
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
I printed out the Rift laptop stand and liked it but wished it was heavier. So I modeled up an adjustable laptop stand that can be filled with whatever you want, I chose lead shot because it was much heavier than sand or concrete and nearly 50% heavier than steel.
The adjustment range is from roughly 14-31 mm
BOM
-4x m3x16 screws
-1x m3x8 screws(for middle)
-5x m3x6 or m3x8 heat inserts
I printed the final in PTEG for extra impact and heat resistance just in case but PLA would work as well. I also used epoxy as I poured in the lead shot just in case it cracked, there wouldn't be a sea of lead shot everywhere.
5 walls and 40% gyroid infill PETG
After adding lead shot and epoxy, the total weight was ~3.6lbs.