QIDI X-Max 3 Magnetic Printhead-Backcover for BTT Eddy probe
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic backcover for X-Max3, with added space for the BTT Eddy probe
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 372
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A magnetic back cover for the printhead, that can be used with the original Printhead without further modification. To mount it, just put the original screws back in and add 6x3mm magnets at the appropriate layer.
The probe gets mounted like it is designed to be, with zero x-offset behind the nozzle. The USB cable can fit in the drag chain together with the tool head cable with some careful massaging.
To use the probe just remove the previous [bed_mesh] and [probe] sections from printer.cfg and replace it with the reference configuration from the manufacturers Github repository. Additionally, there was an incompatibility with the sensorless homing overrides, in the end I deleted everything but the _HOME_X and _HOME_Y macros and used those to reimplement G28 that is already part of the reference config.
A few warnings before you start:
- Do not use a steel nozzle when embedding magnets into the build.
- If you replace the original bolts, do not use stainless. (Those are not magnetic.)
- This needs an unmodified upstream Klipper 0.12 or higher, like FreeDi.
- I was affected by USB disconnects from the unshielded cable.
- The Eddy probe gets really hot (over 90°C) at that location. The safety shut down hits at 100°C. This might need some more thought about the fan placement.
- Printing the back cover in ASA or ABS without the previous iteration back cover on will trigger the tool head thermal safety shut down. It really needs that tiny fan.