Leatherman Wave Holster - Open Belt Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Leatherman Wave / Wave+ holster that has an open belt clip, so it can be taken on / off without removing your belt
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 392
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a Leatherman Wave / Wave+ (might be suitable for other models as well, don't know) belt holster. It is a remix of Scott Sieke's design, which I liked very much, but I needed something that has an open belt clip, so I can remove the holster without opening my belt.
While at it, I also added a couple of notches to better hold the Leatherman in place, and made some reinforcements to the back panel to make it flex less when using the belt clip (this was not required in the original design because the clip was mostly static).
Printing Instructions
- Designed to be printed as-is, in an upright direction, with no supports
- Recommended at least 3 perimeters and 20% infill
- You most likely want to print this in something like PETG, ASA, ABS etc that has a little bit of flex and durability. I used an amazing PETG with carbon fibers from Fiberon which came out really nicely and feels very durable, rigid yet flexible enough for use.
After printing, cut the tiny built-in support fins connecting the clip with the body using a utility knife or box cutter, to disconnect the clip's bottom half from the body (see photo). These were added to ensure the clip doesn't topple during printing without adding annoying slicer generated support.