Replacement Gear for Ariete RoboMax 1786 motor

Asked by a friend of mine, I designed this gear for the motor of a food processor Ariete RoboMax 1786, since the original ones were worn out, and you can buy as a spare only the entire motor at a price of about €70. Initially the diameter of the hole of the gear measured Ø5.00mm, trying it on its pin the size was too narrow, so my friend had to manually enlarge the hole with the drill instead of asking me to update and print again the model. I loaded an STP with the hole diameter Ø5.3mm, the problem should be solved. Otherwise you can modify the hole size by yourself.
My print settings are:

• Material: eSun eASA
• 1st Layer Height: .2mm
• Layer Height: .12mm
• Infill density and pattern: 40%, Cross-Hatch
• Wall loops: 2
• Top/Bottom layers: 5/3
• Print orientation: vertical
• Support: yes, automatic, normal
• Top Z distance: .12mm*
• Bottom Z distance: .12mm*
• Filament preset: Bambu Studio Polylite ASA
• Filament preset edits: Max volumetric speed: 11mm3/s

* Note that I'm not used to print ASA, you should absolutely modify the filament-related settings by your knowledge. My settings ensure dimensional accuracy and only minimal shrinking of the model's surface in contact with the support.

Once printed with these settings the gears worked well.
 

Thanks to Atz for giving me the opportunity to produce a useful component.
If you use it please upload your make and put a like, I'll be happy to know that many other robots have found a new life :)