1 / 4
Rose Backroad AL front pannier lowrider adaptor — zdjęcie 1
1 / 4

Rose Backroad AL front pannier lowrider adaptor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The front pannier rack I own sadly did not fit on my Rose Backroad straight away, so I had to design an adaptor plate.

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
328
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The adaptor plate is mounted to the three existing mounting points on the bike's fork. The rack is then attached using the lowest mounting point and an additional screw supplied with the setup. I’ve installed the lower screw from the opposite direction and secured the rack with two nuts for extra stability.

Alternatively, the bracket could be mounted the other way around, with the extra screw hole positioned at the bottom. However, in that configuration, the adaptor would need to be removed to access and remove the front wheel.

This system has already been tested over a 300 km bikepacking trip without any issues. The adaptor was printed in PETG with 60% infill for strength and durability.

Tagi