Replacement washer for Eiffel style chair legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement washer for certain Eifflel style chair legs that serve as the interface between the legs and body
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement washer for certain Eiffel-style chair legs, designed to sit between the chair base and the metal leg frame.
I created this part after buying a set of used chairs with crushed or deformed original washers. The damaged washers caused the chairs to tilt forward, resulting in an uncomfortable seating position. Replacing them with this printed version resolved the issue.
Printing Info
- Material: PLA works fine, but TPU or a semi-flexible filament may better replicate the original washer's feel.
- Print Time: ~13 minutes per washer on an Ender 3 V3 SE with mostly stock settings.
- Supports: Not required
- Strength: 4 wall loops
Notes
The original washers were made of a semi-soft, slightly flexible material. If you notice any instability or squeaking with rigid PLA, consider reprinting in TPU.
This part was designed to fit a commonly found type of Eiffel-style chair, but fit may vary slightly depending on manufacturer. Minor scaling adjustments might be needed for a perfect fit.