Magnetic Bookmark Holder & Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds and dispenses magnetic flag bookmarks using a pusher inside of a case with a lid.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
This is a 3D printed holder made for magnetic flag bookmarks. It keeps them organized and lets you pull one out at a time. Just print all the parts, load in the bookmarks, put on the lid, and slide the pusher into place.
You don’t need supports, but they might help depending on your printer. If the bookmarks stop moving forward, open the lid and press them down gently to get them going again.
Print time is usually around 30–45 minutes, depending on your printer. It works fine with most common filaments—PLA, PETG, whatever you usually use should be totally fine.
No tools or glue needed—just print it, snap it together, and you’re good to go!