Improved MMU3 Blade Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified mmu3-selector-finda-R3 and mmu-blade-holder-R3 to stop the blades from coming loose.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
The problem I had was that the blades were not secure enough and would leave a gap between the blades. This resulted in the cutter not working.
The parts now use some pins that I cut out of nails. Four pins are needed with a diameter of 2mm and a length of 8mm. The other problem I found with the original was when the holder is tightened it didn't sit at the same angle as the blades and only really held the back part of the blades. A small addition at the back part of the holder now hits first keeping the holder parallel to the blades.
Printed with Prusa's recommended settings for printed parts.