Magnetic DE Razor Blade holder (straight & angled version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two parts, magnetic lock, finger jimping, (not completely un-)ergonomic grip. Used for scoring bread; NOT HEAVY DUTY.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 453
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
Disclaimer: Blades are magnetic; be extra careful when you change them. Use at your own risk. Don't be stupid.
Designed with ease of use and ergonomics in mind; NOT with heavy-duty use. I use it to score self made bread and buns before proofing. Printed with PETG, 0.16mm, 4 Walls, 25% infill. No supports required.
Uses 12 magnets (5mm x 4mm x 2mm)
Magnet holes are designed for super tight fit, so that you do not need any glue. To push the magnets in I use a stack of them and push them in straight from above with a guitar pick to provide a flat back-plate. You need quite a bit of force. Straightness is key here! Pro-Tip: Alternate the magnet orientation for the blade holder so that it can only snap into place when it's at the right position.
If you don't mind gluing them in you may take the “extra tolerance” models with an additional +0.2mm of play for the magnets.
Take care when peeling the prints off of your plate: It is pretty easy to snap them when you just lift the grip. I recommend lifting from the sides.
I would recommend printing the tight fit 45° small grip version which works the best for me. The 45° versions also have slightly deeper magnet holes to fully hold slightly thicker magnets which is a small improvement over the older straight version.
My designs are released under a public domain license: You can do whatever you want with it. I put as much care and attention to detail into it as if it was a commercial product. If my design solved a problem for you, I'd like to invite you to donate me a quarter of a filament spool. These little gestures go a long way and are quite motivating. Thank you!
