1 / 15
Ashleys Kobra S1 - 0.2mm nozzle for miniatures - Settings — zdjęcie 1
1 / 15

Ashleys Kobra S1 - 0.2mm nozzle for miniatures - Settings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Read Description: Here is my latest settings for OrcaSlicer for the KobraS1 main layer height 0.06mm with a 0.2mm nozzle

Ocena
5 / 5
Polubienia
61
Pobrania
645
Wydruki
0
Wyświetlenia
2682
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Please Read Description

 

Only thing to be aware of is the Z offset in Nozzle Settings! 

Currently set at 0 to ensure your bed isn't going to get damaged but for my machine its set to -0.12, First layer prints at 0.15mm so allowing for great adhesion to bed, This may need updating for your printer. Ensure after changing these settings you level your print bed and and calibrate your z-offset correctly for your OWN machine.

Main layer height 0.06mm with a 0.2mm nozzle.

Here is my latest settings for OrcaSlicer for the Kobra S1 - 0.2mm nozzle.

Attached in the project is:

  • Nozzle settings
  • Filament settings (PLA)
  • Slicer settings

For calibration cube i turned off supports and raft layers, however these are recommended for printing miniatures.

 

I've found changes to layer height doesn't impact overall settings.

I've found changes to speed settings doesn't drastically reduce print times.

Based on the "20mm XYZ Calibration Cube" by iDig3Dprinting – licensed under CC BY 4.0

Tagi