1 / 2
The Bat Wing - NVME stuck on heatsink removal tool — zdjęcie 1
1 / 2

The Bat Wing - NVME stuck on heatsink removal tool

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A tool to assist in the removal of stuck on heat sinks on an NVME drive.

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
60
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

I needed to remove some stick on NVME heat sinks as I was repurposing them in a new project with it's own heatsink. Oh lord! that feeling that you will just rip the chips of the circuit board.

So designed and printed a tool that provides a plastic “blade” 2mm up and has wings for leverage so you can slowly apply pressure. 

The blade edge is not super strong, so start with a plastic prising tool to get an initial gap, then slide this blade in and slowly apply pressure, trying to keep the board and tool flat to the desk. 

Bear in mind that there are chips at different heights so don' force this, if you hit a high spot, wiggle a little to create a bit more gap, then carry on.

Be careful, I accept no responsibility if you or this design fails. For me it was certainly better than using a prising tool alone.

I printed in PETG for strength, with the slanted edge face down and on-bed supports. I always struggle with support detachment with PETG so the slanted edge is a bit rough but this is on the heatsink side, the chip side is nice and smooth. 

 

Tagi