USBtingo 9-pole D-SUB case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for the USBtingo CAN-FD Bus interface.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for the great USBtingo CAN-FD Bus interface .
The interface PCB can be purchased from this page: https://www.fischl.de/usbtingo/
I like to use it professionally and privately and would like to protect it from mechanical damage.
The lid is in snap in design. I have used a piece of 1.75mm transparent Filament as a light diffusor to bring the light of the LED through the lid. The filament is glued to the lid using a drop of superglue.
Additional components required:
- 4 x Nuts M3
- 2 x cylinder head screws M3 x 5 mm
- 2 x flat head srews or special d-sub fastening screws to fix the 9-pole D-sub connector
Printed on a MK3-S+ using PETG with theese settings:
- Layer height 0.2mm
- 2 Perimeters, 15 % infill
- Organic support for the bottom
- Random seam position
Hope the model is useful for other makers.