Pride Star Destroyer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution
It's an Imperial Star Destroyer from Star Wars, but in Pride colors.
The coloring is from the Intersex-Inclusive Pride Flag by Valentino Vecchiette, which itself is based on the Progress Flag by Daniel Quasar.
There are three version for three different Star Destroyers - The ISD I (Rogue One, A New Hope), the ISD II (The Empire Strikes Back, Return of the Jedi) and the Resurgent (The Force Awakens, The Last Jedi, The Rise of Skywalker). The images show the ISD I.
Colors
This model was printed without MMU. It needs the following 11 colors:
- black
- brown
- light blue
- pink
- white
- yellow
- green
- blue
- purple
- orange
- red
The model uses a lot of filament changes.
The stern parts go through six colors (black, brown, light blue, pink, white, yellow), with filament changes every 5.3mm.
| stern (port and starboard) | |
|---|---|
| height | color |
| initial | black |
| 5.3mm | brown |
| 10.6mm | light blue |
| 15.9mm | pink |
| 21.2mm | white |
| 26.5mm | yellow |
The bow parts both have filament changes every 10mm, with different colors for port (green, blue, purple) and starboard (yellow, orange, red).
| bow | port | starboard |
|---|---|---|
| height | color | color |
| initial | green | yellow |
| 10mm | blue | orange |
| 20mm | purple | red |
The circle parts use purple with yellow on top after 10mm
| circle (dorsal and ventral) | |
|---|---|
| height | color |
| initial | purple |
| 10mm | yellow |
The bridge is yellow.
Print Instructions
Printed at 0.15mm layer height. Needs supports on buildplate.
Set the Overhang Threshold to something less than 45. This model has a lot of 45° overhangs. Your printer should handle them just fine, but unless you adjust your slicer, it's going to add a lot of unnecessary supports.