1 / 3
Case for the Adafruit Macropad w/ Right Thumb Trackpad
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed case for the Adafruit Macropad and Pimoroni trackball.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for the Adafruit Macropad paired with a Pimoroni trackball on the right side.
Hardware Requirements:
- Adafruit Macropad - Barebones
- Slim Rubber Rotary Encoder Knob - 11.5mm x 14.5mm D-Shaft
- 12 Mechanical Key switches ( e.g., Kailh Mechanical Key Switches - Linear Red - 12 Pack
- 12 Keycaps (e.g., Clear Keycaps for MX Compatible Switches - 12-pack)
- 4 M3x5mm screws
- Pimoroni trackball
- Note: The trackball must be installed with the connector facing downwards. See the picture for an example of the trackball placement and screws.
- 1 100mm 4 Pin Stemma QT Wire
- 4 M2x6mm screws
- 4 M2x0.4mm Hex Nuts
Test code for this MacroPad w/ trackball can be found here:
- https://github.com/spkane/circuitpython-macropad-trackball-tester
- Note: You will likely want a CircuitPython editor and development environment setup.
The original README can be found here: https://www.printables.com/model/138045-adafruit-macropad-case
MAKERS: Please post a picture with comments here of any prints/makes you do from this model so that I can see how people are using it and whether you are finding success with it. Thanks!