1 / 4
Super Deluxe Paracord Melting (Whipping) Form - Melt neat and clean ends on paracord — zdjęcie 1
1 / 4

Super Deluxe Paracord Melting (Whipping) Form - Melt neat and clean ends on paracord

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

New and improved - Optional MMU/AMS/CFS Version

Ocena
5 / 5
Polubienia
30
Pobrania
95
Wydruki
4
Wyświetlenia
415
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

This model allows you to “whip” paracord using a flame to a fine point that will pass through nearly any hole where the paracord fits. It supports a variety of “550” paracord thicknesses from about 3.0mm to about 3.4mm. Handles all of the domestic and imported paracord I own.

Use two M3 screws (6-10mm long) to assemble the hinge. The two side should close tightly, use the tabs to open. Can be used without hinge assembly.

NOTE: The 

 

Whipping Instructions

  • Start with a fresh cut end, already melted ends don't work as well because they often get stuck if not thoroughly remelted.
  • Lay paracord across form in the groove that fits best, the fresh cut end should stick out the wide end of the groove. 
     
  • Close the form
     
  • Melt the fresh cut end of the paracord,I like to melt untilthe inner and outer layers melt together.
     
  • Pull the cord SLOWLY through the form while holding the form firmly shut with the other hand.
     
  • Enjoy, sometimes there is a whisp if plastic coming off the tip, trim with side cutters.