Rack & Worm Linear Slide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This linear slide could be used for positioning optical elements or the like. The 6" linear rail sections can be…
- Ocena
- 5 / 5
- Polubienia
- 103
- Pobrania
- 630
- Wydruki
- 2
- Wyświetlenia
- 3196
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Share Alike
This linear slide could be used for positioning optical elements or the like. The 6" linear rail sections can be mounted end-to-end to create any length rail system. The rails mount with #6 screws on 2" centers, and there are various #6 screw hole patterns on the carriage for attaching fixtures. Please refer to the included STEP file for additional details.
Print Settings
Printer:
UDIO
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament:
Inland PLA
Dandelion Yellow
Notes:
The worm piece has an integral breakaway support piece, so you shouldn't need to turn on supports. Just break away the ring that fills the gap between the knob and the worm gear after printing.
Once printed, clean everything up, apply a little grease to the worm and bearing surfaces and insert the worm into the carriage as shown. Then slide the carriage onto the rail, turning the knob ass you go.Category: Engineering