1 / 7
50mm Air Outlet for Creality Falcon Smoke Purifier YW45 — zdjęcie 1
1 / 7

50mm Air Outlet for Creality Falcon Smoke Purifier YW45

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Do you want to control where the filtered exhaust air from your laser cutter goes? Here is the solution!

Ocena
0 / 5
Polubienia
5
Pobrania
37
Wydruki
0
Wyświetlenia
232
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The Creality Falcon Smoke Purifier YW45 normally blows the filtered exhaust air into the room through the bottom of the housing. However, I wanted to control where the exhaust air goes, so I designed this base that directs the exhaust air into a 50mm hose.

The conversion should only be carried out by specialists who know about electronics! The power supply of the device is unscrewed from the bottom of the housing and placed on the printed base instead. The earth connection must be reconnected to the sheet metal housing (see photo). To do this, the paint on the sheet metal must be scraped off the screw so that the earthing contact is actually established.

Print:

  • Recommended: PETG in 0.2mm
  • No supports (the designed support at the base must be broken out after printing)

Other material:

  • 12 pieces of M3 x 8..12mm flat head screws for fastening the outlet opening to the base
  • 2 pieces of M3 x 8..12mm flat head screws for mounting the power supply to the base
  • M4 screw + lock nut for grounding
  • M4 screws from the original housing to screw the base to the housing

I recommend making seals from 2mm thick foam rubber to seal both the connection to the housing and the connection of the two pressure parts airtight.

Either the original rubber feet or softer ones can be screwed to the underside. Screw holes for M3 and M4 are provided.

Source Code

The part has been designed using OpenSCAD. I have provided the source code for download, so you can adjust the design to your needs.

Happy printing!

If you like this design, then please leave a like and also post a photo in the comments.

You might also want to check out my other designs

Tagi