Zip Tie Anchor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This zip tie anchor is a redesign of PeterEllens' version (http://www.thingiverse.com/thing:24187) but I've made a…
- Ocena
- 5 / 5
- Polubienia
- 522
- Pobrania
- 2435
- Wydruki
- 48
- Wyświetlenia
- 5507
- Oceny
- 40
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This zip tie anchor is a redesign of PeterEllens' version (http://www.thingiverse.com/thing:24187) but I've made a little change so that it prints easily without supports. I've also included a small notch in the bottom to make it easy to pry off the built table. It is 1" square - simply apply a piece of 1" wide double-sided foam mounting tape to the back and you'll have a secure mounting point for small to medium sized zip ties. You can also scale it by 75% if you want to use 3/4" foam tape.
Print Settings
Printer:
UDIO
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
30%
Category: Parts