Glass Prop for Lightweight AMS Riser by Duck Knapp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a small print to allow you to prop your top glass up for venting without removing it.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a prop for your glass with Duck Knapps Lightweight AMS Riser. This allows you to vent your enclosure without having to remove the glass. The leg sits in the small recessed area of the riser inside the lip which keeps it in place so there's no worries of your glass moving. I've been using this for at least 6 months before sharing just to make sure it's secure and actually useful.
Print with the single leg facing up (as seen in picture 3). Supports are needed for the gap where the glass slides in. I used standard profile in PETG, can print with PLA also.