Husqvarna Viking Hat Hoop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on 240x150 Designer1 Hoop this is a complete hat hoop.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed to ease embroidery of a baseball cap, sized as a HV designer 1 or 2 240x150 standard hoop. Includes inner and outer hoop and a bill holder. Requires 2x ¼ -20 x 1.5in hex heads with flat washers and wing nuts for the bill holder. A M6 should work as well. For the outer hoop you will need a M3x60 SHCS and M3 x2 hex nut to assemble the knurled hand screw.
Requires a 350 x 350 built plate due to the size. PLA works best. I used 40% infill. I did try ABS but the outer hoop does not tighten well with the stiffer ABS. Print the inner hoop right side up, outer hoop and bill holder up side down. Knurled nut hex nut up. STL's should be oriented correctly. No supports.