Deep Crimper Pegboard Holder - 25mm Deep 50mm Wide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This pegboard crimper holder is deep enough for the thicker crimpers used on Dupont connectors and some models with…
- Ocena
- 4,25 / 5
- Polubienia
- 26
- Pobrania
- 201
- Wydruki
- 4
- Wyświetlenia
- 851
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This pegboard crimper holder is deep enough for the thicker crimpers used on Dupont connectors and some models with interchangeable crimping bits.
In addition to those types of crimp tools it's useful for attaching a variety of RJ45 Cat5 ethernet network wire crimp tools to peg boards.
Print instructions
Category: Tool Holders & Boxes Print Settings
Printer Brand: SeeMeCNC
Printer: Rostock MAX
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: .2mm
Infill: 30%
Notes:
This printed well with PETG, ABS, and PLA on the Rostock max. Some of the PLA parts were a bit too brittle although that might be a factor of the heat setting being too low and not enough infill. PETG and ABS seemed to be reliably sturdy.
Instructions
Using the following options:
holder_y_size = 25
holder_height = 15
strength_factor = 0.66
holder_offset = 0.0
taper_ratio = 1.0
holder_angle = 0.0
corner_radius = 10
holder_cutout_side = 0.0
holder_x_count = 1
holder_x_size = 50
closed_bottom = 0.0
holder_y_count = 1
wall_thickness = 1.85