Insulated Can Cooler, 2-Pack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insulated can cooler for 2-cans only. For those moments you don't want to haul around a big cooler.
- Ocena
- 5 / 5
- Polubienia
- 242
- Pobrania
- 809
- Wydruki
- 1
- Wyświetlenia
- 4369
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Available in 355ml/12oz & 500ml/16.9oz.
Requires 4x 4mm Screws (or you could just glue it…). Screw holes are 25mm deep, accommodating many screw lengths.
Very minimal supports required on Handle (pivot diameter) and Base (screw holes).
This was designed so you can optionally fill the whole ‘core’ with those gel-beads found in any common freezer pack online. I bought a few packs from Amazon, cut them open, and filled the core. This way, you can freeze/refrigerate the 2-pack cooler to extend how cold your drinks will be. NOT recommended to use liquid from freezer packs, only the gel-beads. This will not seal in liquid.
Recommend printing in 0.2 x 0.2mm ‘fuzzy walls’ on all exterior surfaces for a nice, textured finish. Be sure to add modifiers to the Cap Threads & Handle Pivot locations to remove Fuzzy Walls for a proper fit. Otherwise, the threads & handle pivot may bind.
I printed in white to minimize how much heat it will absorb from direct sunlight. It's all about keeping those bevvies chilly!