Max6675 Circuit Board Housing

This is a housing for the Max6675 modified from bradford's original to better fit my particular Max6675 breakout circuitry. It also removes the lettering on the side of the housing to relieve my printer from having to maul itself attempting to iterate it.

It's also been oriented thick part top to thin part bottom for ease of use when throwing at a build plate.

Once implemented I'll add some pictures to the design. It's going to, in this case, hold a thermocouple sensor onto the back of my PID sensing oven. With high-temp silicon as a thermal heat-break.

Find more of my work at https://pcburn.com

Print instructions

Category: Electronics Print Settings

Printer Brand: Rostock

Printer: Rostock MAX V2

Rafts: No

Supports: No

Resolution: .2

Infill: 15%

Notes:

Printed it out of some translucent PLA I had loaded up.