Cartographer and Beacon z-offset goldilocks tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Its a really simple tool, one side is 2.6mm, the other is 3mm
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 422
- Wydruki
- 0
- Wyświetlenia
- 1487
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
So the instructions are really simple:
Get the nozzle touching the bed (you can use a bit of paper to make sure of this)
Then make sure the 2.6mm side of the tool can slide under the coil of the carto
The 3mm should not be able to slide underneath.
You must use calipers to ensure the tool as printed is the correct height as on my printer I had to slightly adjust the scaling to print it correctly.
You should print it at 0.2 layer height (for all layers) to have the best chance of accurate z-height.
Jul 17 2025 - I reuploaded the model slightly larger to make it a bit easier to use, although it will take slightly longer to print.
Jul 8 2026 - I reuploaded it again slightly wider again and added some bling, I also uploaded a plain version.