1 / 6
Power Extension Cable Gland - Suit 7mm & 9mm Cables with 48mm Plug/Sockets — zdjęcie 1
1 / 6

Power Extension Cable Gland - Suit 7mm & 9mm Cables with 48mm Plug/Sockets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This multi-part assembly uses PETG and TPU parts to create a cable gland suitable for use with typical power cables

Ocena
0 / 5
Polubienia
8
Pobrania
42
Wydruki
0
Wyświetlenia
307
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution

This set of parts was developed to allow an extension cable to be temporarily passed through a sheet metal floor of a stealth camper van when parked up on site power and removed for transit, whilst retaining some kind of seal to the environment. Don't consider this to be a true IP65 rated seal of any sort, so probably don't point your pressure washer at it, however it will at least keep the worst of the elements out if fitted with good quality TPU printed parts and installed in a sheltered location.

Note the sectioned stack-up diagram illustrates the intended assembly. The two TPU gaskets should sandwich the bulkhead/sheet metal of your vehicle/toolbox/shed/whatever you're fitting it to and/or if in doubt, apply a squeeze of silicon adhesive at this interface to maximize the chance of defending against water and dust ingress. Flat smooth bulkheads of up to 5-6mm thick will be suitable with this design.

A hole of 62mm diameter will be required through the bulkhead and the TPU inserts as designed suit cables approximately 7mm or 9mm diameter, with a plug or socket of up to 48mm diameter able to pass through the backshell and penetrator plastic housing.

Examine the provided .3mf files to understand the preferred orientations for printing each part, with included supports to preserve the awkward geometries of the overhanging hexes on the body and shell.

 

Tagi