David Clark headset Airbus electronics module holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Conveniently holds your David Clark headset electronics module on the side clip by the window on an Airbus flight deck.
- Ocena
- 3 / 5
- Polubienia
- 4
- Pobrania
- 132
- Wydruki
- 2
- Wyświetlenia
- 571
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This will hold your David Clark controller box (either the DC One-X or DC Pro-X/X2) on the window headset clip. The controller box is designed to hold the box in only one direction, however the tolerances are loose enough that you can clip the controller box either direction.
Mashing up these two models meant that I had to make a few compromises. First of all, it cannot lie flat along the long side on the build plate, because the Airbus holder was added. However, it prints just fine standing up on the bottom edge (the part that has the narrow passage to clip onto the window). Because it needs to print in that direction, I had to modify the side tabs of the holder so that supports were not required. There is a small amount of overhang on the top, but at least with my printer it was not a problem.
Orient as such:
No more than 15% infill is necessary, and either PLA or PETG works, but PETG will be a bit more flexible.