Quadcopter prop puller - triblade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tri-blade propeller puller for whoop-class quadcopters. This one is designed for Cetus 40mm 3-blade. Hub is 9mm.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 86
- Wydruki
- 2
- Wyświetlenia
- 750
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
Metal fork propeller pullers are difficult to use and results in the risk of broken or bent quadcopter components. This 3D print requires user to pull along the axis of the motor shaft, so no bending occurs.
Device is pressed until hooks engage the back of the propeller hub. User applies firm pressure with three fingers to hold hooks in place while pulling propeller off the motor shaft.
Must be printed horizontally. Use supports from print bed only.
Printed in Prusament PETG.
Center hole in device is for future use in development of a thumbwheel actuated push pin as found in bearing or gear pullers.