Poster Hanger with 1/4-inch wooden Dowel Rods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hang your old posters in a different and complicated way because you don't want to spend $20 per frame on amazon.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
***I used PLA and the posters fell down over time, probably use petg or just use alligator clips instead of or with the printed clamps. Honestly you could just print the middle dowel holder and use alligator clips to hold the poster…***
Have posters you want to hang but you're an adult and taping them to your wall is childish says your wife? Well, she'll love this…
¼ inch Dowel amazon link
The connectors allow the dowels to go in about a ½ inch or something, so they lock in well and wont pop out of the snap fit channel. The rods I used in the link are 12 inches so 2 of them and one connector/hanger will fit most posters. Poster in my photo is 24 inches wide. You can use command strip hooks with this too
If your poster is very curled, you could add a couple more clamps at the bottom + connector which should weigh it down and keep it flat like in the We Can Do It image.
If you have a horizontal poster larger than 24 inches I added an untested model labeled HORIZONTAL, so the idea is place a dowel all the way through and then use a connector on each side to extend the dowels much further. Again, untested so the dowels may bend too much for this application.
Use the LONG version of the pad if you have a poster with heavy curling