BCAR for Foxbat by Sillybutts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BCAR to fit specifically on the Foxbat, with the stock barrel from Out of Darts
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 195
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Public Domain
I designed this 10-degree BCAR to fit specifically on the Foxbat, with the stock barrel from Out of Darts. If you use a longer barrel, just about any BCAR with a 16mm fitting will work. 10 degrees is ideally suited to ~150 fps.
To get a perfect fit around the barrel, I used one layer of clear tape. Note, however, that different filaments and 3D printers can give slightly different results, not to mention that there is some variance with the outer diameter of barrels, so YMMV. This BCAR has been working very well for me - no real drop in fps, and excellent accuracy.
Print with PLA or PETG, at least 4 walls and 15% infill, 0.1 mm layers for best quality (but anything up to 0.3 mm should work). No supports are needed - you'll get the best overhang performance with PLA, 100% cooling (i.e. 100% fan), and a slow'ish print speed (35-40 mm/s). use M3 screws or 3mm pins to assemble, along with nine of the standard F683ZZ Flanged Ball Bearings (3x7x3mm Shielded Chrome Steel Flange Rip Bearings). Enjoy!