No pneumatic fitting required
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
No internal thread for pneumatic coupler. Friction fit PTFE tube.
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 230
- Wydruki
- 0
- Wyświetlenia
- 950
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
No pneumatic fitting? No Problem.
This remix doesn't require it. It's a smooth bore hole now so just run the PTFE tube straight through as is.
Provided 3mfs for you with a few options ranging from 3.90 to 4.20mm in 0.05mm increments, depending on printer tolerances and your PTFE tube.
You should print a test model to check out the fitment first. Use any of the provided 3mfs and just slice and print the inner race of the spherical bearing. When you found a good fit, reprint the whole thing. Remember to print the nut too, which you can find in the original design page.
If you need something out of the provided range, ask in comments and I'll help you out. If you need to change other parameters of the general print you can find try the modified OnShape project here: