Fiio K11 Stabilizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stabilizer for the Fiio K11 DAC amp combo.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
"The bottom is an enigma of what the f--- is this Fiio?!" - "It tends to rock around" - Z Reviews
This 360 side skirt serves as a stabilizer to keep the device from flipping when you press on a corner or side. It is slightly less tall than the built-in rubber feet on the device. This maintains the natural grip and prevents the print from scratching the desk.
The corners and midpoints have widened areas (1cm) for double-sided tape.
The height that worked for me was 5.4mm. I printed on a smooth plate, and it came out with a slight elephant's foot. I recommend printing only one corner at first, and use that to see if you can slide it under your K11 without lifting it up, and have an acceptable gap left over.
Wall loops: 4 (will make the thin sides 100% infill)
All other settings can be default.
Filament: 4.42 m / 13.19 g
Cost: €0.26 (based on €20 per kg)
Time: 1h 20m (SV06 tuned for lower noise)