1 / 4
Pour-Over Coffee Spout for Corning Revere Gravy Separator — zdjęcie 1
1 / 4

Pour-Over Coffee Spout for Corning Revere Gravy Separator

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This adaptor fixes the "dribble" of the separator spout and directs a finer stream of hot water into the coffee.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
68
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Share Alike

I am new to pour-over coffee making and lack much of the basic equipment.

I found two Corning/Revere gravy separators in my wife's kitchen cupboards, so I recruited one of them as a “poor-man's” pour-over kettle.  The spout on the separator tends to dribble, so I decided to try to print myself an adaptor.

The Pourer 35 by NicoConex was almost ideal for my needs.  All I had to do was measure the internal diameter of the separator's spout and model a small cylinder that I could “jam” far enough into the spout to stop the water leaking past the adaptor.  I merged the cylinder with the original pourer to make this one.

NOTE: I also cut the pourer on a 30 degree slant, thinking it would mate with the face of the spout.  The cylinder is a tight fit about 15mm before that slanted face reaches the spout, though.   Rather than continue to develop the model, however, I decided to stop while I was ahead.  When you print this model, I recommend that you select “Make overhangs printable” in the slicer (Cura offers this option, anyway).  That way, no supports are needed.

Tagi