Heltec V3 desktop case - 3000mAh and 18650 batteries compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for placing on top of a horizontal surface, fixed placement style. Ample battery space and room for GPS
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 70
- Wydruki
- 1
- Wyświetlenia
- 1115
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked HD_Creator's concept but didn't like the top cover and the button design. It was too small for my batteries, so I redesigned it from scratch.
Board is now secured into place by the walls behind it, and buttons are standalone. Battery compartment allows for a 3000mAh 103665 or up to 2x 18650 (without battery holder), and even a GPS addon board+antenna to be mounted on top of the batteries (untested).
Fit is a bit tight between the USB port and the topmost button, depending on your printer tolerances you might need to trim the button off slightly to be able to slide the board in.
You'll need 4x M3 bolts, minimum 5mm long each. They self screw directly on plastic, test them first of all for easier handling.
Use a standard rocker switch like these for toggling the battery on or off.
No need to bend the wifi/bluetooth antena to fit inside the case.
Depending on the antenna used (especially on the ¼ wavelength monopoles that the Heltec comes with, not required on dipoles like mine), a ~10cm wire taped to the lid's top inner side of the lid and connected to the SMA ground will improve reception. Refer to HD_Creator's model for example pics.
Use some tape for keeping the battery in place.
Print settings:
- Box: top up, activate supports
- Lid: upside down, activate supports
- Buttons: 2x, wide side down, no supports required
Model from pics done on black PLA, 15% infill, 2 perimeters