2.2 Rims for wide "taoon" tires
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rims for a different tire
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
These are some tires I’ve found work amazing on heavier rigs. They’re slightly wider than most 2.2s, which gives them extra grip and stability. If you’ve checked out my profile or seen any of my builds, these are what I run on my Kenworth. They grab onto basically anything—and they’re especially solid in snow.
🛞 Wheels: I just use the default wheel centers from Rex.
🔩 Rim lockers: I run the ones from the “A” set of Morrigan’s aftermarket parts.
🔗 Morrigan Rim Lockers on Printables
🚛 Rear section: This is the Black Cow Rex rollback rear I built mine off of (can’t link it normally due to licensing, but here you go):
🔗 Rex Rollback Rear – 1/8 Scale 6x6
🛞 Tires:
These are the exact tires I use on Amazon. Great grip, especially in snow.
(Full disclosure: That Amazon link is an affiliate link, so I earn a small commission if you buy through it—at no extra cost to you.)